Replace male chips with homemade lamps

Hello guys !

For newcomers, proudly owning a chip packing machine with a value of 20-100 million is a really troublesome factor. So what’s the low-cost however efficient answer? At present I wish to present you the right way to change male chips with home made lamps for less than   about 400K. Brothers put together:

The instruments for making male chip pins I discussed: grid for making chip pins, solder grease, lead ball…
Infrared lights purchased at medical gear shops, typically used to deal with joint ache and bone ache for the aged, price about 350K (on the time of writing).
Body (rack): Used to hold up the mainboard, you go to some iron retailers and say they solder it, it prices about 50k.

By changing the male chip with this home made infrared lamp, it’s each low-cost and doesn’t kill the chip. I’ve achieved many of the work and have not seen any useless. And may change the bulb about each 4 months (solely purchase the ball, this long-term use ball shouldn’t be as sizzling as the unique) purchase about 80k ball. Brothers admire their home made male chip machine.

Steps to take to interchange male chip with infrared lamp:

Take away the useless male chip from the mainboard through the use of an infrared mild, put solder paste on the chip’s stomach and  activate the sunshine and await about 2 minutes, then use tweezers shake it gently to see the chip transfer. Be aware that you must shake the 4 corners to see it earlier than taking it out, in any other case you’ll lose the pins on the primary, right here I’m engaged on the primary gigabyte GA-G31M-S2L utilizing the GB chip. When eradicating the male chip, it’s essential to take away the cmos battery, take away the capacitors close to the male chip, open the socket cowl, the northern chip heatsink to keep away from exploding and exposing the socket or the north chip pin because of warmth.
Take out all of the lead on the mainboard, put solder grease and lead wire to wash the lead on the mainboard, you should use a soldering iron to get it shortly. After cleansing, use aromatic gasoline to wash.

1. 

2. The mainboard after cleansing the lead and being cleaned with acetone, you proceed to place the primary on the worth of the infrared lamp (from the highest of the infrared lamp to the primary about 1.5 – 2cm) after which put a bit of little bit of chipset solder grease and apply evenly. Use the male chip because the foot, seek advice from: make the male chip pin, placed on the primary reminiscence to appropriate the path (the white arrow with the letter A is the pin #1). After fixing the chip, you activate the sunshine to the best degree (line 5) to shut the male chip. About 1 minute noticed the chip tip collapsed, solder grease melted 4 edges of the male chip, the chip was already hooked up to the primary. You employ the tongs and gently shake the 4 corners of the male chip. Keep in mind to shake it flippantly, shake it too laborious to make the balls stick collectively, it takes time to do it once more. After shaking the 4 corners of the chip, flip off the sunshine, use a fan to blow on the chip to make it cool, then use fragrant gasoline to wash it and plug within the energy to check to see if the system is on, obtain the usb and laborious drive (changing the male chip shouldn’t be customary) don’t acknowledge usb, hdd ).

With a home made system from infrared lights and a holder, you should use it to interchange the chip, reheat the chip, and shake the chip on the video card (but it surely is dependent upon the cardboard). I’ve used the  KADA 853A chip steamer, however discovered it not as efficient as this infrared mild, you should buy a further torch holder above the chip to assist take away the chip quicker and extra effectively. Have enjoyable.