Asus motherboard when booting up the dos display screen instantly reported an error:
CMOS Settings Flawed
OVerclocking failed!Please enter setup to re-configure your system.
Chassis intruded !
Deadly Error…System Halted.
This illness solely happens in most important Asus, when having this illness, the machine hangs proper on the Dos display screen, unable to make use of the keyboard to enter the CMOS. This illness additionally has many causes akin to hanging keys, bios error, lacking bounce chassis, lifeless fet… To repair the chassis intruded error on Asus mainboard, it’s worthwhile to comply with the next instances:
+ On the mainboard there’s a jack to plug within the jumper, look fastidiously to see if the bounce chassis is hooked up, if not hooked up, the machine will boot usually and no error message might be reported. The image under is the primary Asus P5 KPL AM I eliminated the jumper and circled within the crimson rectangle.
+ If on the mainboard has a bounce chassis mounted, you proceed to take away the CMOS battery, or take away the cmos bounce being in place 1-2 is regular, change to place 2-3 is obvious function to revive bios to residence state manufacturing, then change again to the previous place of 1-2 as proven above.
+ Mounted bounce chassis and clear cmos, however the machine nonetheless provides an error: Deadly Error…System Halted, then you definately proceed to take away the 4 filter capacitors positioned behind the PS2 port, this filter capacitor is eliminated and the machine nonetheless receives the important thing usually. , leaky filter capacitors, noise additionally trigger this illness. Brothers and sisters within the image under to take away 4 filter capacitors.
+ Comply with the three steps above if the machine nonetheless exhibits an error, then you definately proceed to take away the 3-legged fet close to the chassis jack. The second image above me has a small 3-legged fet circled. This fet supplies voltage to the chassis jacks. If the fet is detected, shorted, damaged, it additionally causes the machine to endure from the above phenomenon. And that is the commonest case on this illness, often after I see this error, I probe the circuit from the chassis foot to the 3-pin fet and take away it.
These are the methods to repair the mainboard error when the machine says Chassis intruded ! Deadly Error…System Halted. And I’m profitable, hope that can assist you acquire extra expertise in repairing mainboard. Want you success in work and life. Pricey.
